Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi,
okay leave this float.
Thanks
1671706881
Hi,
What about the CLKIN, CLKOUT, and TEMP, can I leave it float or should I mark is as Unconnected sir?
Many thanks.
Jess
Hi in the LTM4644 (https://www.analog.com/media/en/technical-documentation/data-sheets/LTM4644-4644-1.pdf), page 7 its says that " COMP is Current Control Threshold and Error Amplifier Compensation Point of Each Switching Mode Regulator Channel. The internal current comparator threshold is...
Hi FvM, I know that I can leave the PGOOD unconnected but since I am going to use in my circuit I think it is important, other than the connection of PGOOD in the power it is also connected to the Power Status Leds circuitry.
Hi. I just wander on what supply I should pulled up to the resistor?
Here is the situation. In the LTM4705 IC from ADI, page 13 of its datasheet (https://www.analog.com/media/en/technical-documentation/data-sheets/ltm4705.pdf). it says that ". A resistor can be pulled up to a particular supply...
Hi, I am trying to use the ADI module regulator LTM8053 https://www.analog.com/media/en/technical-documentation/data-sheets/LTM8053-8053-1.pdf.
And I tried to look for its EvalBoard or the Demo manual, in ADI they do have demo manual for their specific ICs in order for the consumer to have a...
Hi, I am just wondering how to use the A3 pin or the PGOOD and the B5 or the SS or soft-start of LTM8051. Since it was not stated in the datasheet on how are we going to used it. Would It be using a pull-up resistor or can I directly connect it to different component??
I tried to compare the...
Hi everyone, I would like to know your insights about the functions of SHDN, ENOUT and FLT pin in LT4363 this is a surge protection IC. I copies the circuit in the typical application since I am also using a 28V input.
I should let this float or maybe connect it to somewhere or maybe mark as...
Hi everyone, I'm having a problem in restoring the QSPPI flash because when I run the bat file in windows command prompt it says that The system cannot find the path specified.
I already put the path in the system path environment. why this is happening?? Should I download Xilinx SDK software...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
