Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi Silvio,
Thanks for yours useful informations.
My application needs 2 CAN(High priority & Low Priority traffic) and 2 Serials UART (1xRS232 & 1xRS422).
Do you have a example in C of a Bootstrap to progamming the FLash memory?
Regards,
Maximilius26
winburn flash memory burner
Hi,
Anybody have working whith this MCU?
I'm looking for a Flash Tools Programming like Winburn(www.microware-tech.com).
Thanks in advance,
Maximilius26
Touch screen
Hi all,
I'm looking for a schematic for a touch screen panel (resistive - 4 wires) and the code if there is a microntroller.
Thanks,
Maximilius26
portb latb
Hi,
For the Pic 18 Series:
Reading a I/O port or bit uses the "PORT" register.
Writing to an I/O port or bit should use "LAT" register.
Regards,
Maximilius26
Hi,
I've the CD Elektor 2000-2001...
Each Cd have 4 langages (English,French,Duits,German) for every project...
There is a possibility to upload an article of your choice.
Regards,
Maximlius26
P.S.: The CD 2002 is not available at this time.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.