Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Re: What is best method for channel estimation in IEEE802.11n with 108 data and 6 pil
this code is orginal by made me. just I want to next step adept with other parameters.
my problem with this section (channel estimation), I know for 4 pilots with these loops, with 3 repeats with 16 iterations...
Re: What is best method for channel estimation in IEEE802.11n with 108 data and 6 pil
First, thank you for your good advice to me.
I'm interested to use an only single antenna, after getting the result without error, change to the MIMO system.
First: Initialize the parameters for the 802.11n...
What is best method for channel estimation in IEEE802.11n with 108 data and 6 pilot?
Hi all,
Does anyone know what is the best algorithm for channel estimation in "IEEE 802.11n" with (108 data sub-carrier and 6 pilots)?
Because when I use the Channel Estimation based on Pilot-Assisted Linear...
Given the information, I have and study. I know for Generate preamble signal "802.11a/g with 20 Mhz - FFT size 64 point -16QAM". For example, like this:
For short preamble
S1 = [1+1i 0 0 0 -1-1i 0 0 0 1+1i 0 0 0 -1-1i 0 0 0 -1-1i 0 0 0 1+1i 0 0 0 0 0 0 0 -1-1i 0 0 0 -1-1i 0 0 0 1+1i 0 0 0 1+1i...
Hi all,
I'm trying to write Matlab code for OFDM receiver block for 16QAM. but I have an error with reshape command.
Bit_Num = 4;
FFT_Num = 64;
Carrier_Num = 48;
OFDM_per_Symbol = 1;
CP = 16;
LI = 12;
Np = 4; % Number of pilot
Carriers = 1:Carrier_Num + Np;
N_Num = Bit_Num * Carrier_Num *...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
