Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi,
I've the design of an antenna and the design of the SMA connector. I'd like to instantiate the SMA inside the design of the antenna. How can I do this? Cant find a way to do it...
Thanks
is there a way to tell calibre to write the correct dimensions?
for example, what about modifying the calibre cellmap in the calibre view setup window or the "reset properties" field?
Hi,
I'm using calibre pex to extract a single transistor:
W=1, L=0.06, NF=2, M=1.
The result is that in calibreview I'm getting two transistors:
W=1, L=0.06, NF=2, M=1
W=1, L=0.06, NF=2, M=1
I noticed that the number of transistors I get is the same of the NF. The netlist however shows:
W=1...
Hi everybody,
this is my first post in this forum, even if I've always been looking with interest to a lot of posts :D
I'm working on a project where the quality of the post processing in BB strongly depends on the phase error between the two LOs sin and cos of the receiver. I was wondering, is...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.