Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
MicroController failure - Vcc and GND short. I also checked the board for track short but no track short identified. After replacing with new mcu, its working fine.we observe this failure randomly.
Regards,
CMA
Hi
I am using a STM32f0 family microcontroller
but its getting failed in different stages Reason for that is vcc to GND pins shorted. We are facing the issues in both at our supplier, in-house and customer end.
I thought this might be because of 3.3V supply regulator L78L33ABUTR. But there is...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.