Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hello all
Am simulating a circularly polarized frequency selective surface using HFSS Floquet port model In a unit cell configuration.
In order to achieve circular polarization, i have defined port one wave one to 1W, 0 deg Phase, and port one wave two to 1W,90 deg phase.
After running the...
Hello all!
Am modelling planar surface characteristics with some surface roughness using HFSS V 14, Groisse model at 30THz.
In the set up, there is a check box for layer thickness. What layer does this refer to? Am using the finite conductivity set up.
thanks.
1) Wire antenna such as Dipoles, Monopoles should use Lumped ports.
2) Horn antennas should use wave ports;
3) Planar antennas fed with coax feeds, microstrip, stripline or other transmission line
feeds can use either Wave or Lumped ports;
Are you designing the complete system or you are just interested to know the componet list? this is a problem for an Engineer and am not sure an MBA person can handle it . talk to your supervisor.
Re: BJT
Hello
make sure the transistor is well biased and then you can supply your signal.make sure the signal strength is not much greater than the biasing voltage otherwise you will drive your transistor to saturation
Re: AC Inverter Circuit
Hello!
Any serious power electronics boook will help you on that. you can either use transistors or thyristors, but of course transistors circuitly will be easier though abit low power inverter.
good luck.
plc based generater aufomation
Hello!
just use the common sensors to do the project. for temperature you can use the thermocouples or tehrmistors to sense the water temp, ofcourse you will require to do some signal conditioning and calibration. for water level sensing you can use the normal...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
