Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
When AD7321BRUZ collects voltage, a spike voltage appears at the input every time it is acquired.
After the input is opened, the ripple voltage is shown in the following figure:
Can you explain this situation.
When I use STM32L072RBT6, according to the interrupt vector mapping of CM0, use the following code; for example, my APP address: 0x08006000;
I copy the interrupt vector table of this address to the actual address of RAM, such as 0x2000000, the total size of 0xc0 is limited;
Then perform...
I want to make a car, use the driver module, just have a piece of ULN2003 on hand, just think about whether you can use this chip to drive, check the DATASHEET, the current of each port is 500mA, I use the two ports in parallel Do a mouth control 1 motor, a total of 4 ports control 2 motors, the...
I bought a few AH211Z4-AG1 products, I haven't found them for a long time, and finally found them on https://www.winsupport-ic.com.
My friend also recommended a platform for electronic components procurement from China: https://www.hotenda.com
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.