Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
hii.
i was learning the gsm module for last few days.i got the point that while CALL,we sent burst of 4.615msec each containing 8 time slots.only one slot is used by a user(consumes burst current ~2A).for remaining time,the module consumes typical call current(~200mA).
i need to know the how sms...
i need to know the current consumption profile of general GSM module
i.e. different processes and their corresponding current consumption lyk call current,idle current.
thnx
can any1 explain me how smps starts after active low signal on power_on pin of atx? wat actualy happens inside smps???
intel motherboard guide states that if we press the poweron switch for less than 5 seconds,it turns on.if we press for more than 5 seconds,it turns off.how this works?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
