Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi,
I am new for the IBM SiGe BiCMOS 0.13um Process.
There are bondpad and bondpad_inh in the Schmatic,but no pad. There are bondpad and pad in Layout.
When I simulate the Schematic, should I put in a bondpad in my design? Or after layout design put in a pad in the layout.
and it is right and...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.