Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Thanks for the reply Alexan_e.
What I want to do is a communication between 2 ATmega (128 and 8) via RF modules, but it can be modeled as a simple wire.
I have a main base (ATmega128) and three bases (ATmega8). The main base must send a value (1,2,3) to select which base should transmit and then...
Hello. I'm working on a project with Atmega8 and I'm switching the code from ASM to C (easier to me), and I have one doubt.
It should send 40times a value via UART when it reaches 1sec.
In assembly I used to work with Timer1 cause I needed fosc/PRE * seconds = 1MHz/256 *1sec= 3906 cycles.
Here...
Hi, I'm developing a program about RF positioning.
I have a main base and three bases located in a known area.
What a partner did before was that every base sent a value to the main one every X ms (no overlap with the other bases). And it worked "fairy" well. (The guy had to activate/deactivate...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
