Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Recent content by mahesXtremeEngineering

  1. mahesXtremeEngineering

    Operation of MCB shunt tripping module

    How does the shunt tripping module for MCB works. Has anyone disassembled one
  2. mahesXtremeEngineering

    About internet and IPv6.

    What do these settings do.
  3. mahesXtremeEngineering

    About internet and IPv6.

    In our web browsers there will be a window like this.... what are we setting here...
  4. mahesXtremeEngineering

    About internet and IPv6.

    How can we find the server IP address of a particular site?
  5. mahesXtremeEngineering

    GSM Module Simulation in Proteus

    I don't know if proteus(version 7.2) have gsm module in their library . You have to connect it to the physical serial port of the PC using MAX232 IC. You can connect your PIC to a serial port model in proteus which allows you to communicate with the device on physical serial port of PC.
  6. mahesXtremeEngineering

    About internet and IPv6.

    Recently i have heard that the internet is changing to IPv6. Does it change all the server IP address to IPv6. Is there anything we(client) need to do about this.
  7. mahesXtremeEngineering

    Unexpected shutdown of desktop pc

    Is the voltage levels shown on SpeedFan ok. #26 I doesn't seems that the heat from the connector is transferring to the nearby components. The capacitor itself is heating. Maybe because they are bypassing more current(AC component). Voltage levels shown on speedfan is not accurate 12v. Right now...
  8. mahesXtremeEngineering

    Unexpected shutdown of desktop pc

    Yes, now i am worried about the power supply. The capacitors and voltage regulators near the PSU pins are red hot. And the ram chips also. Does a bad PSU can cause this if it has more AC component in its output voltage.
  9. mahesXtremeEngineering

    Toy Motor on 5V supply

    From where does this 4v comes when both components are connected in parallel.
  10. mahesXtremeEngineering

    which is best for learn microcontroller

    I was asking for a material which covers all AVR GCC. Eg. In AVR GCC a delay of 100 milliseconds can be made by... _delay_ms(100) ...while writing a program what if i got confused it with delay_ms(100) or delay-ms(100) , from where can i recall the exact syntax. For commercial compiler their...
  11. mahesXtremeEngineering

    which is best for learn microcontroller

    What about AVR GCC. Is there any good source(book) for learning it.
  12. mahesXtremeEngineering

    Why ballast kick voltage do not get bypassed through starter?

    dselec said about windings and oil bath which are not present on modern ballasts.
  13. mahesXtremeEngineering

    which is best for learn microcontroller

    Which is the best source to learn AVR.
  14. mahesXtremeEngineering

    Why ballast kick voltage do not get bypassed through starter?

    Is this high voltage applied across the lamp or across a filament.
  15. mahesXtremeEngineering

    Why ballast kick voltage do not get bypassed through starter?

    Are they sending continuous voltage spikes even after kicking the lamp. Isn't it loss of power.

Part and Inventory Search

Top