Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
No its not. The lumped port have to connect the inner conductor with the two outer conductors. Eventually use a sheet of perfect E to connect the lumped port to the outer conductors
Eventually like this: https://obrazki.elektroda.pl/4794382100_1360526422.png
Hope it helped,
Mads
I am currently running a simulation on a transmission line where i use two lumped ports:
Port 1 have an Impedance of 50 Ohm
Port 2 an Impedance of 10 kOhm - 132j Ohm
I am looking at the coupling between the two ports, in other words: S12
So should I run with both ports renormalized to get the...
Hi Everyone.
I am relative new to HFSS, so I really could use some help to this one problem.
Im trying to measure the coupling between a Coplanar waveguide and a probe.
I have excited my CPW with to lumped ports, placed my probe 10 microns over the CPW and placed a Wave port on top of the...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.