Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I had used middle four port pins of controller i.e P1.2 to P1.5 as my data output pins to LCD(D4 to D7). I'm facing difficulty to solve this.
Earlier i had performed LCD interfacing with 4-bit mode successfully with P1.4 to P1.7 as data output dins, but by changing pins it is not working ...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.