Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Thank you for that information. Now I can read the data communicating with the usb and computer.
IanP,
Now, how can I use the make an emulator using the data gathered?
I what to re open an application requesting a software key.
Is there's a way to re open an application requiring software...
I would like to know if rs485 can get the communications between computer and a usb device?
If it is possible how? If not, could you give me another solution. Thank you in advance.
There is an application needs a dongle key to open. That is why a what to read all the communications between the computer and the dongle key. First, from the time the dongle key is inserted. Then, when the application is openning.
I am using is C++ programming language.
Could you please help me about the program I am working now?
The program is all about checking the string for valid pair or pairs of bracket/s.
{}[]<>()
Then printed "Valid" or "Invalid".
Here are the samples:
Input: Output:
{}dsafsdf Valid...
I would like to capture the message from One panel. The panel has a printer fort. a serial printer port. I want to capture particular text like ALARM the Followed by Z001. Then, the LED 1 will lit. I preferred 9600 baud. And I'm using Atmel 2051 MCU.
The Question are:
1. Can I use polling...
You should know the speed of the motor and the speed of your clock. To calculate the delay needed to synchronize the messages you want to appear.
---------- Post added at 08:15 ---------- Previous post was at 07:45 ----------
You may use the speed sensor of the motor. Then, make a program to...
Ianp,
Thank you. Back to original idea but when the one of the pin triggered and activates one motor. then, the time is in the middle of delay(let's say about 2.5 seconds) the other pin triggers. what modification to turn on the other motor while the other motor turned on in a middle of the...
ITgirl,
I think your english is good. As long as the idea of what you are typing is clear you can able to communicate in this forum. Even I, is not very good in english.
Even in programming you can understand that
JMP is jumping from one instruction to another.
Am i correct?
So that...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.