Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hello All ...
I am using SIM900A module ,, Fabricated a good PCB ,, The module is not accepting any command but echoing every command ,, I am unable to set echo OFF , I am using SIM900A V2.03
I've spent too much time ,, but got response of only following command
AT+IFC=1, 1 (Software Flow...
Hi ..
I've developed my own hacking board ... click following link ,,,
https://www.flickr.com/photos/maan2k/3887210352/
further ,, I figure out the pinouts and quickly prototype the carrier board (not more then 1 hours work) .. and then Implement a master hacking software which I developed...
Well I need 3 hours to Hack Nokia N85 , or any Nokia LCD (Fabricating carrier board + Implementing S.W ) ,, but when I could spare that 3 hours ,, its not sure :D:D:D:D:D:D:D
Imran :D
Hi ...
I have hacked many Nokia LCDs including 6500 Slider :D:D:D:D
Nokia 6600/7610 , E51 , E66 , E71 , 2700 Classic , 6500 Slider , N73 .. Any many more on the ways ..
one of them is here on sparkfun ..
https://forum.sparkfun.com/viewtopic.php?f=14&t=20935&start=0
Imran Naeem...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
