Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Dear ALERTLINK,
I went to this website and I know the fuse low and high values "0xFD and 0xD9 respectively", the only problem is that I'm using the Genius G840 programmer to burn the .hex file to the micro-controller and I don't know how to set the fuses using the G840 software, do u have any...
Thanks for your reply,
no problem, it's just that I had a 20MHz crystal lying around and after I checked the datasheet I though I could use it. But I have no problem NOT using the 20MHz, what I want to do is to speed it up a little bit that's why I want to use an external crystal...any idea on...
Hi there,
I was working with the atmega8L micro-controller using the internal oscillator 1MHz and baud rate of 2500, but now I would like to use an external crystal 8MHz "or higher either up to 20MH" with baud rate 9600. I use the AVR Studio v4.18 to write my code and I have the Genius...
Re: atmega8 rs-232
Dear microcon555,
I was working with the atmega8L micro-controller using the internal oscillator 1MHz and baud rate of 2500, but now I would like to use an external crystal 8MHz "or higher either up to 20MH" with baud rate 9600. I use the AVR Studio v4.18 to write my code and...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
