Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
lmd18245 cnc
I am new at this stepper motor control but have seemed to find quite a lot of information on the web. I would like to build a stronger controller later being that the Allegro only handles 1.25 amps but I wont to use this one to help make the pcb for the next controller. I started...
unc5804b
Hi unplugged
I am using the allegro UCN5804B chip on mine which only is good for 1.25 amps. While all my motors are 1.4 and 1.5, am looking to change this problem I hope, seems I am getting a fortune involved in current limmiting resistors every time I want to make a small change...
make cnc without stepper
Hi; anyone have an interest in stepper motors and building the controler circuits?
Am new to this but learning the hard way (hehe) the trial and error method. Working on a cnc router/engraver right now.
Mike
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.