Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hello,
I would like to know if there is a possibility to use a voltage monitor results (Voltage over frequency) from a 3D simulation as a voltage source in a schematic simulation in CST ?
Is there a described process somewhere that explains how it can be done ?
I can export datas from...
Thank you very much for your replies,
@psach27 : I've already tried with the AC combine results. The main issue is that you need an AC source in the schematic part. And here, the Plane wave is the source.
@volker@muehlhaus: this is an interesting way with the reciprocal approach. However, I...
Thank you very much for your reply.
Actually, this is the way I am trying to get results from CST.
You will find attached the EM/circuits parts that have been splited on CST. The goal of the circuit is to do a RF to DC conversion. So I need to get the DC value at the end of the circuit...
Hello everyone,
May I have posted it on the wrong section so I will move it to this section.
I am currently trying to create a CST co simulation for a rectifier antenna. The simulation is broken down into 2 steps: the dipole antenna is simulated on the 3D section and the circuit part is on the...
Hello everyone,
I am currently trying to create a CST co simulation for a rectifier antenna. The simulation is broken down into 2 steps: the dipole antenna is simulated on the 3D section and the circuit part is on the schematic section, the excitation is done with a wave plane in order to...
Hello all,
I currently have a simulation of 3 dipoles with an excitation port for each one(see screenshot below):
If I run the simulation, the combination of both E field result at low frequency should give me a nice sphere.
For one dipole, this is the diagram I get from the simulation:
I...
Thank you for your reply BigBoss.
The goal of the simulation is to define until which frequency the schottky diode could be used. Because of the RLC elements, it should have a cut off frequency that will not permit the diode to work properly, am i right ? This is the reason I used the frequency...
Hello everyone.
I am Ludovic from France and new on the forum.
I am currently trying to simulate the cut off frequency of schottky diode (KEYSIGHT HSCH9161) via ADS for a RF to DC converter. However according to specification, it does not seem to give the datasheet result.
I have 2 different...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
