Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I try to simulate in LTSpice an NMOS transistor with a 3 finger layout. That is, the Wfinal = Winitial / 3 and CSB = 2CSB / 3.
How should I simulate this in LTSpice? does the parameter "parallel devices M" already do that? or how should I use the values "source area AD" and "source perimeter...
Hi,
i am designing a Butterworth LPF 8nd order with OPA with a frequency cutoff 20Khz. The most important parameter is the current consumption from the circuit (OPA + external component).
I would to know what kind of synthesis technique is the best for my requirement.
The classical Sallen-Key...
Hello,
someone can tell me how to properly connect the ground.
The primary side is actually connected to ground, while the secondary side is floating (not ground connection)
I have tried not to put ground in the secondary (leaving floating), but the simulations are not correct.
I add a...
Hi,
I have the BSIM3v3 model provided for the vendor, but a lot of parameters defined in the BSIM manual are not included, such as: Nsub, Xt.
What make the simulator in this case? Does it use the default values from this parameters from the manual or just it ignored this parameters in...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.