Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Could you help me to setupt propertly the hfss to simulate this flipped transmission line ?
I could't find any example of this situation, as you can see in my 1 message i try to setup a cable conect to a a pcb board in oder to measure the flipped cable, one side conect direct to board GND and...
Hi FvM , this is a veriety of regular wilkinson, and about he length in my model in HFSS is a variable, so the 20mm is just for reduce the simulation time .
The wilkinson diagram is the one below , ( sorry is just a pain diagram , because im out of office now).
As i told you in real tests it...
Thanks for your reply .
In fact im trying to simulate a compleat wilkinson combiner that use the regular 2 lines 70 ohms from port 2 and 3 and use 2 cables whit the shield and inner crossed and a 50 ohms load to ground , it workd fine in real world and i can get over the UHF band a veru good...
I´m trying to simulate in HFSS a Balun cable , and try to get the same results as i have in Genesys , i alredy test it in real world and Genesys result are very consistent , so i´d like to undestand what im doing wrong in HFSS.
Below is the circuit in Genesys ( it is a line 20mm 75 ohms )...
I d like to find the theorectical calculation to design a UHF slot antenna , i found some info only for waveguide slotted antenna , bu im interesting in the coaxial ones .
Like...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.