Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I've managed to manually route all the traces for both power and ground. I still can't place the polygon pour though. I'll like to have a ground pour on both layers of the PCB. And yes, I did assign the net when doing the pour.
I can't attach the file, so I'm giving a link to the .PcbDoc file...
I have managed to route the power signal to all the required pads, so now I can place ground pours on both layers instead. Does this make it any easier? I still can't generate the pour though
Hey guys!
I'm new to this forum and Altium as well.
I'm laying out a double sided PCB that must remain that way due to cost.
I have finished laying out the traces for all the signals, except for a power signal and ground. I found it near impossible for me the route the two signals to all...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.