Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
hi,
it's fine with isis simulation now i am facing problem with the vb.net interface i am not able yet to send data through usb to pic??
any suggestions?
this my whole project i am trying to compile it but it does not work.
- - - Updated - - -
this my whole project i am trying to compile it but it does not work.
thanks for the reply,
the Isis simulation does not work because of the virtual usb driver installation ;i have already installed it but the same error is over and over displayed.
hi,
the card is supposed to power control through vb.net interface data (time on/time off) must be sent via usb port to the card then the number of interchanges from on to off will be displayed on lcd display .
this is what my project is about hope that someone can help :) .
thanks
hi,
I am dealing with a similar project connecting pc to card based on µcontroller via usb port i have problem making this connection please may anyone help?
thnks
hi,
i googled and no answer :( i don't know what to do to make my project work.now i have a problem with isis simulation i have missing usb driver which i couldn't install
my vb.net code is not working neither.
hi ,
i'm working on a project similar (pc to pic communication via usb port seding time in minutes through vb interface) i have already done all the steps above ,wrote my vb and mikroc code but i still have problem finishing my project :( ,i cant make sending data work yet.
please may anyone help?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
