Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
dc parameters in cadence
Thanks ,
Excuse of my ignorance because Iam so new in Cadence, could you explain more ?
I already sweep vgs but this is not an issue
The problem is, I can't select the gm in calculator, I can see it only in Result display window not result browser hence when I select...
cadence dc sweep transistor parameters
Thanks for your hint,
How I can plot these parameters,
for example if I want to plot gm vs VGS what should I do ?? any idea..... I am looking for your answer ...
mos id vs vds in matlab
Have a look at this website :
http://www.ph.unito.it/~cobanogl/
and find the Tutorials inteh left hand side by the name of:
Estimating CMOS Hand Calculation Parameters (K, µCox, Vth and lambda)
It says step by step how to calculate the Lambda .
cadence dc operating point
Hi group,
I run a DC sweep simulation on ADE (using spectre) and I would like to
plot some of the DC operating point parameter of my schematic(such as
gm, gds,vdsat of the transistor which I can not see for example gm in the Result Browser ).
How can I add...
The drain current doesn't follow the square law equationin short channel like 90 n technology so it does not make sense if u are looking for K,
ID= w*vsat*C'ox(VGS-VTHN-VDS,sat)
for more informatiopn about short channel design refere to : Jacob Baker 's "CMOS" book.page 153
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
