Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Well my output requirements are around 7-10 seconds.
I am using high drain IMR batteries.
Other supplies work at 5-6A without a problem (off course draining the battery a lot) but that's what i want.
I do not plan to go below 3.2-3.3V (way above the 2.750v cut off)
Hello!
I would like to use a high discharge rate Li-Ion Cell (3.7V) and design an adjustable power supply, my requirements are:
1-10V output voltage.
If possible up to 10A. (i realise that may not be possible when my output is high voltage)
Load resistance from 0.2 or 0.5Ω up to 3Ω.
Smallest...
Hello!
I have build one ICD PICS rev.B.
My problem is that MPLAB doesn't connect on it. When i try to connect mplab shows "Connecting to MPLAB ICD 2" , the progress bar moves but it stays there forever, only when i disconnect the icd2 it stops with a failed message.
The USB driver is installed...
Re: Nokia 3510i schematic
if you want the schematic and even more of them you can go to https://portal.sedf.net and download them.
there are also firmwares and service manuals
Re: Mobile polling
**broken link removed**
Attachment deleted by davorin...
Reason: Available at nokias website under: https://www.nokia.com/cda1/0,1080,1528,00.html
Do not again upload stuff available on internet!!!
Warning #2
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.