Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi Klaus
I'd like a Tx and Rx mikroBasic code (one direction communication) only, Nek or Sony Syrc or Philips protocoll communication .
The 12F675 MCU as Tx and 16F88 as Rx asTv, AVR IR remote control(i'll use only four switchs because the 12F675 is a little MCU).
I don't need a full-duplex...
I'm sorry to the stupid stars but i made a copy and cat from another link using my phone !!!! :wink:
This is the code:
======= The code wrote by pkar ========
unsigned counter = 0;
unsigned input_data, bit_count;
enum {
Idle,
Start_bit,
Capture_bit
};
char Current_state = Idle...
Hi guys
I need to traslate your c ir tx code in mikrobasic code for 12F675 , could you help
me? because there's some c istruction not simply to traslate for me.
In addition if you can could you help me to write a mikrobasic tx code using 16F88 device?
.
Ps: before post this message i tried to...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
