Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hello ,
I have PIC18F46K22 and I am using the internal oscillator 16MHz no PLL.
I want to enable the CLKOUT function on OSC2 which is on RA6 pin.
I am using MikroC PRO for PIC From Edit project in oscillator selection I selected : internal oscillator block,CLKOUT function on OSC2 and in my...
@pjmelect
thanks for help, I tried your software but the problem is the same . seems that the problem is proteus.
at this point I will try to unistall it and then install it again , maybe it will solve the problem.
Hello,
I have Porteus 8.1 and I am using COMPIM to connect my pic , the first time I run the simulation every thing work perfectly , when I stop simulation and run then run the simulation for the second time, the COMPIM will not work . I investigated and the problem seems to be is that even...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.