Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Yes it is in the "tab layers", and I have them in the thermal relief and anti pads. The problem I am having is all I see is regular pads.... the thermal relief or anti pads don't show up? I don't understand what step I missed or what I am doing wrong. That is why if someone can give me an...
Sorry, Orcad PCB Editor and Pad Designer are the two programs I am using to make the board layout!
- - - Updated - - -
The issue I am having is I used the thermal relief and anti pads in the pad designer to create my pad stacks but when I look at the 3d image the stacks are not correct. I have...
Okay this information was very helpful on how to create the thermal relief, but the next problem I run into is I add it to design pad stack and it doesn't appear in my part. I do have it turned on in the setup / design parameters.... So can you help me understand why it is not showing on my pad...
Hello everyone,
I am struggling with how to create thermal reliefs and anti pads because all I see is the regular pads. Even when I insert the thermal pad in my pads they don't show on my planes, that are turned on in the setup/design parameters. Can someone break down this for me, I...
Hello Everyone,
Does anyone know how to do a route and retain in Orcad PCB Editor? If so can you explain it to me, I am new to Board design so please be specific. I have a board outline and components on the board but I have two boards attached to each other and want to make on break...
Hello Shabu,
I am appreciate all you help. I just needed you to explain it to me in a different way for me to realize what the errors were. Thank you for taking the time to explain it to me.
Greatly appreciative,
Lee
Hello,
Can anyone help me with this error? I have replace the part, changed the footprint, and most of the basic things I could think to do to fix this error. I am a new PCB Designer and need a little help, I am struggling to understand what I am doing wrong. I would appreciate any...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.