Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Dear GURU's
I would like to sniff the UART transmission between two uC, what should I do ? I have data cable which has Rx, Tx and GND signals, how should I connect the data cable to the bus ? Do I need any resistors or diodes in order to not interfere with uC communication ?
Regards
Lazureus
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.