Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
You need to use the following menu option to provide the tear drops. Route-Gloss-parameters-Fillet and tapered trace.
Using this you can modify your tear drops as per your requirement.
In my design i am using press fit connectors for which i need to be backdrill the pins.The layer count in my design is 18 Layers.Do i need to backdrill all the layers?As of my knowledge backdrilling is done from bottom for this scenario but will it be done on the other side as well?How do they...
While designing in a PCB Layout tool,I would like to calculate the copper area for specific current requirements.For example the current requirement is 160 amps and i need to draw appropriate shapes in Layout.My question is firstly how will i calculate the copper area for 160 amps and secondly...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
