Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Good morning,
I have a small problem understanding the turn-off of diodes. I am thinking in particular about the turn-off of the secondary side rectifier diode of the flyback converter.
Until now, I assumed that if the diode current reaches zero naturally without any forced commutation, one...
Thanks a lot for the response. Here is the circuit I am trying to simulate:
It seems that these oscillations are less of a problem if the on-time is higher. Can I expect to see similar oscillations in the real circuit? (I ask this as I would like to avoid using any RCD clamps etc. if possible)
Hello,
I am currently working on a simulation for a bidirectional flyback circuit (output diode replaced by a NMOS). When I am using generic components, everything works fine. However when I use
manufacturer supplied spice models for the MOSFETs, I keep getting unwanted oscillations while the...
Good evening,
I am currently working on a Dual Half Bridge converter. At the moment I am a little bit stuck at the capacitor selection (capacitors C1-C4 on the schematic). In particular I am looking for capacitors of about 370uF which can sustain a ripple current of 25A rms (they are placed at...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
