Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Recent content by kumar_praboo

  1. K

    Is there any boost converter with synchronous rectification

    Friend, I am also searching that please help me...send syn boost converter topology.... Regards, JK
  2. K

    fpga-based motor control

    Use driver unit(TTL) logic for amplification of pulse from controller.......................
  3. K

    need help for Using TCA785

    using tca785 In datasheet itself applications notes is there......try that ckt,,if doubt means ask.... Regards Kumar
  4. K

    Need circuit to control three phase Scr controlled rectifier

    TCA785 By using TCA785,i want to control three phase Scr controlled rectifier...please send the circuit for me,,,i am trying lot for that,,,, Can u help me.....? waing 4 ur reply...? Regards, Kumar
  5. K

    Half-Controlled Single-Phase Bridge Circuit - help needed

    TCA 785 Can anyone done the Half-Controlled Single-Phase Bridge Circuit with Two Trigger Pulse Transformers for Low-Power Thyristors? If so means help me,,,,,wat voltage you r giving to that rectifier input?wat is d SCR ur used?,,,,i am not getting proper output,,,,please help me if u can...
  6. K

    Help with Triac Control for up to 50mA Gate Trigger Current using TXC10M60

    txc10 m60 change the capacitor value,increase that value of 10th and 12th pin capacitor.if u change input voltage means u have to change the design,so give 230 v AC,,as per the circuit,,,check the ground properly,otherwise shorted,,,,,,,, try u will suceed
See more

Part and Inventory Search

Back
Top