Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi,
I am trying to make a UWB pulse generator in Agilent Advanced Design System. the paper i have been working on is mentioned below. In this paper a pulse is generated by using a step recovery diode.
http://wcsp.eng.usf.edu/UWB_Testbed_Docs/RedRinging.pdf
I need to simulate the circuit using...
unfortunately i dont have any reference mic :sad:
can i use normal headphone mic ????
also i mentioned about singal generator and osciloscope can i use them to find the frequency response??
thats the way if i make that hydrophone fist ....
but i want to check the frequency response of the piezo element like this
i have a spectrum analyser and a frequency generator in the lab
can i check the frequency response with these two lab equipment ???
if yess i donnt know the...
hi all,
i am making a hydrophone for research purpose. I have found a very good and low cost method to make it.
**broken link removed**
but still few things arent clear to me . I am using condenser mic or a piezo element from a piezo buzzer. how can i check the frequency response of the...
problem in nmea parsing
hello all
i m doing a project of gps datalogger n i need to parse the gps sting
i m using Proton Development Suite compler to compile the code i m interesed in latitude and longitude of the string i m uploading my code but it not working it jst waits for the $GPRMC...
thanx 4 the help but i how to connect that virtual serial port driver software with proteus
virtual serial port driver makes the pairs of the of COM ports but how to use it if u can help
Regards
Ali
i am doing a project of gps data logger
for that i am simulating it on proteus software
i want to read the GPS co ordiates on proteus and show them on the lcd
i have done the lcd interfacing but i dont know howe to connect the hyper termial with proteus
i want proteus to read directly form...
hey
i am doing a project in which i need to interface an alpha numeric keypad with PIC controller .
the keypad is alpha numeric just like the one in cell phones
any help will b appreciated
so thnx in advance
i am making a project of gps data logger
can it b done with 8051 µC or i have to use AVR controller
also i have to interface PC-AT keyboard with it so this controller should also support that
help me on this plzz
thanks
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.