Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
SEGV Signal Error on defining "CON.RESIST" IN "CONTACT" statement in Silvaco
I have been getting error when i am defining "con.resist " in the CONTACT statement as
"contact name=source con.resist=5e-06
contact name=drain con.resist=5e-06...
I am new in learning Silvaco n trying to simulate Pentacene OFET
Three problems
1. What models to assign in MODEL statement (i have taken only PFMOB)
2. For simulating Top contact OFET the gap between S/D electrodes filled by vacuum
Do i need to define vacuum on top of Bottom contact OFET as...
I am new in learning Silvaco n trying to simulate Pentacene OFET
Three problems
1. What models to assign in MODEL statement (i have taken only PFMOB)
2. For simulating Top contact OFET the gap between S/D electrodes filled by vacuum
Do i need to define vacuum on top of...
(1). I want to know how i can set a nominal , absolute and sigma value for monte carlo simulation of simple NMOS of L=0.35 u and W=10u with level-53 model parameters in HSpice tool
(2). why variations in parameters changes with different absolute variation?
(3). if i use gauss then no...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.