Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Recent content by Kristian

  1. K

    how do I connect an infrared temperature sensor to a pic?

    pic cpu temperature sensor OK - thank you . I will try to connect a second amplifier and see if I can counteract the input from this to give me a faster steady state for the system. Your help has been much apriciated. Kristian
  2. K

    how do I connect an infrared temperature sensor to a pic?

    ir temperature sensor I just see now that I got one of the labels wrong. The top label that sais Thermopile GND is supposed to say thermistor... The rest of the information is what was available from the producers datasheet - if you can get some information out of that regarding the correct...
  3. K

    how do I connect an infrared temperature sensor to a pic?

    pic thermistors temperature Hi Fvm Than you for your reply. I Have tested as you said by replacing the ir-sensor with a 60 kOhm resistor. I get fine readings that vary one or two bit as you said. I know that your respond is regarding the noise level on the amplification but maybe you could...
  4. K

    how do I connect an infrared temperature sensor to a pic?

    ir temperature sensor project Hi again I am fairly new to electronics and programming so please excuse me if i am slow on the terms :-) I am using an analog low pass filter at the moment ("10muF, 16V", with 46kOhm resistance). Regarding the ina128p, I am using 50 ohm resistance on the gain...
  5. K

    how do I connect an infrared temperature sensor to a pic?

    infrared temperature sensor +project Hi FvM Thanks a lot for your reply. I have not mesured the noise level from the amplifier or the sensor yet, I will try to do this as soon as possible. Also I will try to get hold of the ina 114 amplifier. I have conducted a series of tests (the most...
  6. K

    how do I connect an infrared temperature sensor to a pic?

    infrared temperature sensor Hi. Im working on a project where I need to incorporate an infrared temperature sensor (ZTP-135SR). The datasheet from general electrics is very spartane in information. On the sensor there are four wires - A thermistor, a thermopile and a ground wire for both the...

Part and Inventory Search

Back
Top