Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Recent content by kreitzz

  1. K

    Wireless pulse oximeter design using MSP430

    I used Nellcor type sensor with DB-9 connector, manufactured by Launch, China. It has a photodiode inside.
  2. K

    cost effective solution for 15 min timer switch

    Hi! Another cool link with SW and HW, officially supporting Pic10F (not all models): **broken link removed**
  3. K

    cost effective solution for 15 min timer switch

    I have some PIC10F222 (or F202), so I could check and let you know. My idea is to use combination of MultiPic v2 with WinPic SW, also I have PonyProg and PicKit2 so I will try all of them ))) ---------- Post added at 09:11 ---------- Previous post was at 09:01 ---------- I have just found...
  4. K

    TUSB3210/3410 firmware

    Hello! Fortunately I could provide you with this files. I have found them very hard... Look on attachments..hope it helps ))))
  5. K

    cost effective solution for 15 min timer switch

    Hi! Also you could try MultuPic programmer - very good (tested).... MultiPic v2
  6. K

    cost effective solution for 15 min timer switch

    You could see the PIC10 MCU series ($0.30) - from 6-pin MCU in SOT23 package...also try PIC16F630A, PIC12 series, ATTiny13/15...
  7. K

    Wireless pulse oximeter design using MSP430

    Hello! Project was done for about one year ago. Please find some fotos below... I open to questions! Technical data: •Signal type……………………PG; •Sensor type………………..Nellcor DB9 probe; •Wave length………………..660nm / 940nm •SpO2 range ………………..70-100%; •Pulse range………......…..25-250 beats/min; •SpO2...
  8. K

    Wireless pulse oximeter design using MSP430

    wireless pulse oximeter Any ideas?
  9. K

    Wireless pulse oximeter design using MSP430

    pulse oximeter design HI! I am last year student and I am working under my diploma - Design of a Wireless Pulse Oxymetry device. Looking for sources about this project, I've found one very interesting project, based on the MSP430 FG437 MCU application datasheet from TI: **broken link...
See more

Part and Inventory Search

Back
Top