Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I tried to make something I figured out this circuit. But I couldn't find a way to block lower levels. For example if I have 5 V as in figure, it doesn't go through R3 yes its achieved, but it shouldn't go through R1 as well it should only go through R2. Transisors and other IC's forbidden...
Hi I want to make a voltage selector circuit with opamps and diodes etc. (no IC's except opamps) but I couldn't find a way, do you have any advice for me ? Its like a dot display level meter (dot not bar) but I can not use LM3915 etc.
I have a varying DC voltage and want to make a circuit that...
Yes I know how to implement comparators with opamps. But I didn't understand how they discrete levels of microphone output ? Aren't they work as giving output of their Vcc or -Vcc so doesn't it mean that I lose my microphone information, and still I couldn't understand how it seperates.
First of all yes it is homework but I worked on it and stuck at only this part. Maybe I am approaching on wrong side I am open to every advice.
I need to design a environmental noise checker circuit. I am not allowed to use any IC except OPAMPS! Passive elements (resistors, capacitors...
Hi i implemented a vhdl code for checking results from TCS34725 there is no error in my code and i checked everywhere to correct and make it flawless but it does not work at all.
I am not very good at i2c i just know the main logic behind it so i think my problem is connected to i2c but i dont...
TCS34725 Basys3 VHDL
Hi I am trying to use TCS34725 to identify Green and Red Colors, it has I2C interface and i could not find any I2C interface about this and i am not capable to write a protocol code what should I do I am stucked.
I just need when it sees green it turns one led and when it...
Hi, I need to make a circuit which does the following thing:
When it sees a red object it will send output 0 until it sees a green object (like a well colored cubic toy), after it sees green it will send output 1 until it sees red again. ( If it is hard to implement I'm ok with just output 0...
Hi, I am a 2nd-year ee student, and I need to make a term Project. With BASYS3 by using VHDL.
My purpose is constructing a car which can be controlled with the buttons on BASYS3 ( I think I need Bluetooth module for it to RC a car). In addition to that my car should stop when it sees red ( i...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.