Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Shouldn't really make a difference. To maintain a decent power factor over such a wide range (0-3kW), the device probably has some kind of active PFC boost circuit built in, which means could feed it pretty much anything. Input magnetics, EMI filter, might be the only thing to look at. They...
I understand how to select a value to resonate. The problem is optimal power conversion for a desired power level at my given load. (And desired output voltage, if that's important.)
How do I optimize L and C for a given load for maximum transfer at a given power level? I could easily select a...
I'm looking for general strategies, not a solution to any specific problem.
As an example, though, let's say I'm going to target 50kHz +-5kHz as my operating frequency.
How do you select L and C in a parallel loaded resonant converter?
For instance, pretty standard topology, I think, here:
Let's say I'm controlling input frequency to tune in a desired output power through R. What general strategies would you take to select some set of optimal tank...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
