Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
The signal generator is making and it should produce 3 waveform and can adjust frequency and amplitude. Now, I am using Ad9833, MCP41010 and AD8051 and Arduino UNO (can change to Mega if needed) to do so. However, I don't know how to write the program of the part of adjusting the amplitude. Can...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
