Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
No, vias are associated with gnd.
For this can be used inspector maybe.
In my case, where a lot of vias are almost touch each other can be simple removed tick "check for incomplete connection". but this isn't good solution.. straaange
Hi. I have the same problem today. Suggest a solution. You can remove vias and then add them again. This helpad me. If via will only touch the pad then there should be a track to solve this. If removing/adding will not help. Try to remove and then add vias but first via place in the center of...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
