Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hello,
I am trying to implement a model in Simulink for wlan Receiver.
As part of it, I need to implement a Barker Correlator.
Barker Sequence [+1, –1, +1, +1, –1, +1, +1, +1, –1, –1, –1 ]
I need to multiply the incoming samples with the barker Correlator. Barker Correlation is done to...
Hello,
I would like to understand what is CCK Modulation? How is spreading achieved in CCK ? What is the difference between CCK Modulation and Spreading using Barker Code.
I am trying to implement the modulator and demodulator for CCK Modulation used in IEEE 802.11b. What is the optimal...
Hello, I am implementing the DQPSK modulator and Demodulator. I was successful in implementing the DQPSK modulator. But, unfortunately, I could recover the samples from the modulated signal.
As the help indicates and I quote, "If the Output type parameter is set to Integer, then the block maps...
Hello,
Can you suggest me how can we demodulate the DQPSK signal in Simulink, using the Xilinx blockset. I am implementing in FPGA, hence I need to use only the xilinx blockset.
Any pointers for the tutorial would be helpful as well.
Regards
Kiran
handoff using matlab
Hello Everyone,
I am a student and working on the Handover Decision at the BTS and Node B(3G).
I have to simulate Hard Handover(HHO), Soft and Softer Handover(SFO).
I need to simulate these Radio Resource Management functions using Matlab.
I am not an expert using Matlab...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
