Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hello all,
As a part of my project now I need to design a circuit which converts 60UA to logic 0 and 40UA to logic 1 .Please help me out.
Thanks in advance ,
Regards
Karthik
Hello rangermad ,
I have L and XL licenses also but previously I used different pdk now I am using different pdk ,it is not opening now.Please help me out.
Hello all ,
I am not able to open layout in layout L and layoutXL but I can open in layout GXL.But I am not able to define pin names which is needed for lef file
extraction.I am attaching screenshot of my error , please help me out.
Regards ,
K.Karthik
Hello ,
The thing 28nm in your case means that it is the minimum dimension a device can have.In analog design
we aim for higher gain which is dependent on ro . ro takes the value which depends on length. Hence length should be more.
We all know that .lib file is used in synopsys.I am designing a new standard cell and update .lib file.So can anyone provide information regarding cell_rise and rise_transition and cell_fall and fall_transition and rise_power and fall_power .
Regards
K.Karthik
Hello all ,
I am an ardent user of cadence.Here by we have calibre license in our college.But it is not getting displayed in the toolbar.Earlier it is displayed but when I used NCSU free pdk it is not getting displayed.Please help me out in solving this problem. I am attaching screen...
Re: Quiery regarding creation of .db in cadence
Hello pancho_hideboo ,
Thamkyou for your replies.I understood my error.So I will try to resolve it.
Regards,
K.Karthik
Re: Quiery regarding creation of .db in cadence
Hello pancho_hideboo ,
Please go through my cds.log commands given below in this document .Please help me out
\o Use/reproduction/disclosure is subject to restriction
\o set forth at FAR 1252.227-19 or its equivalent...
Re: Quiery regarding creation of .db in cadence
Hello pancho_hideboo ,
I have tried that solution before posting , it is not loading the NCSUFREEPDK tf file/
Awaiting reply ,
Regards
K.Karthik
Quiery regarding creation of .db in cadence
Hello all ,
I am ardent user of cadence virtuoso.I am using NCSUFREEPDK45 . Can anyone tell me how to obtain .db file from .tf file.Actually while I was loading it is failing to load .Please help me out...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.