Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hello again,
Yes i'm a student for electrical engineering, and teking a course in analog circuits. Unfortunately, design isn't a part of the course at all, only analysis. So i'm a bit clueless because design is quite new to me.
I need to design an amplifier with the specs mentioned above.
I may...
Hello everyone,
as a part of a course in analog circuits, I need to design a BJT amplifer with the following parameters:
Voltage gain = 51[dB]
Rin = 55[ohm]
Rout = 50[kohm]
Band width: [10kHz,1MHz]
DC suppliers allowed: +/- 5V
The purpose is to as less stages as possible.
I thought about using...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.