Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Thank you very much for your time and effort (+1), much appreciated :)
..that was what I was afraid of :/, I was hoping that somehow they could recharge each other or just draw less current from the smaller once, however case solved :)
BTW. my IMR's are unprotected :/, they are so called "safe...
Is it safe to connect several IMR (lithium manganese rechargeable) cells of different sizes (capacitys), same voltage into a 12V battery?
I have two 18650 IMR 4.2V and two 18500 IMR 4.2V cells. Would it be safe to connect 3 of 'em (or all 4 of them for another matter) in series and make a 12.6V...
Ohh, ic ic, now, there is no need for 2 regular and one variable as in my set-up, just make sure that the 10 or 11k after the potentiometer eats at least 6.5V. :)
Ohh that, I tought bot tht -->> tried to measure resistance, no luck -->> so I tought Ill try with 1/4W resistor and if it gets to...
First of all thank you both very much :D (+1 BOTH!), special thanks goes to BradtheRad for the schematic drawing (even tho I'm not yet familiar with all the symbols nor the term "100K impedance", nor do I understand how a 10K resistor can provide variable voltage) I'll go back to Electronics for...
Dear all :)
Thank you very much for your time and effort, any replays would be deeply appreciated.
Would this be safe to try and would it work? Thx in adv :)
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
