Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Recent content by kickeyes

  1. K

    Reduce Vdd form 5Volt to 3.3Volt in AMS CXQ 0.8u technology

    Thank you very much, It is obvious
  2. K

    Reduce Vdd form 5Volt to 3.3Volt in AMS CXQ 0.8u technology

    Normally, Vdd of 0.8u use 5V,so can it use to design opamp by using Vdd = 3.3V? If Vdd=3.3V. is typically,Can we consider worse case form 2.7-3.6V?
  3. K

    What is the parameters for calculating of AMS CXQ 0.8u

    I use this value for calculation. It is error to 75%. It cannot use the simulation because I use Bsim3v3. So, The best Solution is using corner analysis or monte carlo. But Corner analysis and monte carlo have not licence. T T I'm necessary calculate by manual. How to assume the condition for...
  4. K

    What is the parameters for calculating of AMS CXQ 0.8u

    Parameter of 0.8u technology, Kn=90u , Kp=30u , Vtn = 0.8V , Vtp = -0.9V I am not sure.
  5. K

    What is the parameters for calculating of AMS CXQ 0.8u

    Doubt , I know it is secret. (T T)
  6. K

    What is the parameters for calculating of AMS CXQ 0.8u

    I calculate to follow equations of Bsim3V3 but Values are not correct. I need to know Kn. Kp (Transconductance Parameter) for design circuit opamp.
  7. K

    What is the parameters for calculating of AMS CXQ 0.8u

    Thank you, I see file already, but I didn't see Kn and Kp. How to calculation this parameter.
  8. K

    What is the parameters for calculating of AMS CXQ 0.8u

    0.8u technology What is the parameters for calculating of AMS CXQ 0.8u such as Vthn, Vthp , Kn, Kp. Lamda and so on. I use Cadence Simulation.
See more

Part and Inventory Search

Back
Top