Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
reduce r7 and r5 with equivalent ratio.
Place one resister of 460E at base of Q1.
Hope this will work...
Then go to Audio amplification section of LM324
Digital is always best for short or long distance communication
Noise affects more in Analog signal.
Lots of available chips give you digital o/p so cost is less.
and so on....
i Will post u one link within one day because i am unable to find menu of attachment.
code is for CS5460 but not with Atmega,
So just u need to change port definition.
try it with spy-bi wire connection
---------- Post added at 17:04 ---------- Previous post was at 17:01 ----------
You can update latest .dll file at specified path for IAR or for CCS
for more detail search and download latest dll for iar in google
Hello,
I need to measure DC current in terms of pico Amp.
Applied voltage is 1000Vdc.
Path Resistance is More than 1 Tera Ohm.
I need to measure in noisy environment.
i just gave basic diagram and it is not with pin diagram
and it is the common thing that VCC is +10 V
Image circuit is tested with circuit maker.
4 mA @1V
20mA@5V
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.