Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
The material is cloth with a teflon type coating sprayed on to it. I have thought about running it through a set of pinch rollers to guage the speed, but am unsure what to use as a feedback. A tach would not put out any voltage at such low rpm unless we greatly geared it up.
I have a 90VDC motor and gearbox running a spool at 1 RPM. Empty the spool is 4" in diameter. It has an aproximate linear speed of 12 inches per minute (pi X diameter). Full, the spool will be 16" in diameter (approximaely 48 inches per minute). So as the spool takes up more material its...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.