Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
HI JC,
Thanks for that. I added the capacitor since from seeing it on another forum but thanks for the tip. Board is all working fine again. 555 timer was broken along with a couple of other components, built a tester and this showed it was faulty.
Thanks for the help.
case closed:)
Kev241.
555 negatine
Hi ian P.
Thanks for the reply. So the circuit attached should work fine with the capacitor connected to negative 5 v and pin 8 and 4 to GND and pin 1 at the lowest potential ie -5v.
Just want to be sure as im a bit of a novice at this.
Thanks again.
555 timer power supply
Hi I hope someone can assist me with a small design question regarding a 555 timer IC.
Can a 555 ic be operated using a negative power supply? with the the usual positive voltage connected to ground?
I was given a circuit to power a 555 ic using a -5v connected to pin...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.