Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Allright, I was unaware of that chip series! I will have to re-solder them as they are currently in a matrix, but this eleminates the need for a controller for sure!
Allright, this is the current list:
2M WS2812B LED strip
IRFZ44N MOSFET's, to switch the 12V for the 2m RGBWW LED strip. (Strobes and monochromatic)
5V/12V Dual power supply (5V for the controllers, ADC and WS2812B, 12V for the other ledstrip).
PCM1801U as ADC, 16 bit, 48 kSPS, communication...
It will be a raw estimate as I will be making a full block schematic tomorrow. I would like to have enough reserve to swap some things out if they dont fit or add more LED's.
At the moment we are looking at:
2M 60LED's/m WS2812B -> They draw about 50mA each with RGB all on. 60 * 2 * 50mA = 6A...
Hi
the past few years I have been experimenting with different LED setups to make them reactive to music.
In order to complete my project I would like to implement the following things:
- A 16 x 32 LED matrix spectrum analyser (5V)
- A 2m WS2812B LED strip (5V)
- Stereo 2 x 8 LED VU meter
-...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.