Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
cc1100 pcb
I try to send data via RF with CC1100. After I read Datasheet with carefully and try to develop it.
I not much knowledge in RF. I don't understand most configulation bit. I Use SmartRF Studio to help. But it still not work.
I found some problem.
1. I not have spectum analyzer to...
interfacing of 89c51 with eeprom
In each byte cycle of it not over 5 ms. Free time before process in new byte ~ 1.2 us
That mean you can reduce that time to 1.5 us it enough
In normal use you must pull-down in Write Protect Pin.
Recomment Pull-Down very well.
WRITE PROTECT (WP): The...
best clocking pic18f452
In my last project I try to use crytal 10 MHz and PLL, yes 40 MHz it come but it not stable. If your project don't need more than, 20 MHz it well.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
