Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
[By calibrating the gain and offset potentiometer 50 k and 100 k respectively. ]Why now? What did you change?
µF? Really?[Yes; C2 as per the datasheet.
C2 (µF) =100/fFS; if fFS ≤ 100kHz; 0.001; if 100kHz < fFS ≤ 500kHz;
0.0005; if fFS > 500kHz or C2 = 10²/FMAX]
Hi,
I am using Keysight DSO-X 2024A for frequency measurement.
Now I am getting linearity for 0 to 10VDC. I am getting 10kHz for 0 V and 110 kHz for 10V.
Fout= Vin/ 7.5 R1 C1
where; C1= One-shot capacitor(in my case 285 pF)
C2= Integrating capaciotor(909µF)
R1=Input resistor(in my case 40kΩ...
Hi,
Thanks for your reply.
Please find the attachment of the circuit I am using for voltage to frequency conversion.
I have set 10 kHz for 0V and 110 kHz for 10V. For the voltage between 1 to 9, I was getting some random frequency like 310 kHz for 2V, etc.
Also, the Behaviour of the practical...
Hi,
I am using VFC32 as Voltage to frequency. I want to make circuit that will convert 10 to 110 kHz signal in to 0 to 10V.
I was getting 10 kHz for 0V and 110 kHz for 10V but i didn't get linearity.
How to get linerity in VFC circuits.
Thanks.
Regrads,
Kartik patel
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
